DESCRIPTION

. Remove the enclosure from the main body by loosening the three enclosure fixing screws using the tamperproof screwdriver provided with the camera.

2. Detach the dome cover from the enclosure by removing the three dome cover fixing screws. (At this moment, the dome cover and the main body is still fixed with the dome wire. Remove the fixing screw of the dome wire.)

 3. Replace the dome cover.

 • Peel off the protection film from the new dome cover. (Carefully perform the installation work to not to scratch the dome cover.)

 • Make sure that the waterproof packing on the new dome cover is being stuck without torsion or transformation. Use only the attached waterproof packing of the new dome cover.

• Put the enclosure, the new dome cover and the holding plate together using the three dome cover fixing screws. (Align the grooves of the dome cover and the holding plate, and then align the guide of the enclosure to the aligned grooves.) Then, fix the dome wire using the removed fixing screw after aligning the wire between the protrusions on the holding plate. Tightening torque of the dome cover fixing screws: 0.78 N·m {8 k gf·cm} 4. Put the main body and the enclosure together using the three enclosure fixing screws. Tightening torque of the enclosure fixing screws: 0.78 N·m {8 kgf·cm}

4. Put the main body and the enclosure together using the three enclosure fixing screws. Tightening torque of the enclosure fixing screws: 0.78 N·m {8 kgf·cm}